Hands-On AutoCAD LT ©2005

Chapter 6: Mechanical Dimensioning

Notes and Leaders

1.
General drawing notes are usually placed
A)in the upper left corner of the drawing.
B)in the upper right corner of the drawing.
C)in the lower left corner of the drawing.
D)in the lower right corner of the drawing.
2.
The text produced by the MTEXT command is made up of
A)multiple lines of text that are considered a single object.
B)multiple lines of text, each of which is an individual object.
C)a single line of text on which you can change text styles and other characteristics.
D)a single line of text that can be edited with the DTEXT command.
3.
The margins of multiline text are set by entering the MTEXT command and selecting the
A)Justify option.
B)Height option.
C)Style option.
D)Width option.
4.
To add symbols to multiline text,
A)pick the Symbols button on the Multiline Text Editor.
B)display the Text toolbar.
C)right-click to display a shortcut menu.
D)pick the Symbols option on the Insert pull-down menu.
5.
The symbol code for the diameter symbol is
A)%%d.
B)%%c.
C)%%p.
D)%%o.
6.
When a note refers to a specific part of a drawing,
A)a leader is used to point to the proper place on the drawing.
B)the note is placed as close to the geometry as possible so that an arrow is not necessary.
C)a thick line is used to connect the note to the geometry.
D)the note is placed inside a box or circle and placed near the geometry.
7.
A leader consists of a line with
A)arrowheads at both ends.
B)a hook on one end and an arrowhead on the other.
C)a hook on the end nearest the geometry.
D)an arrowhead.
8.
To create a leader, use the
A)LINE command.
B)ARROW command.
C)QLEADER command.
D)QDIM command.
9.
To specify a different type of annotation at the end of a leader, select the Settings option and then select the
A)Annotation option.
B)Leader Line & Arrow option.
C)Attachment option.
D)Hook option.
10.
Notes with leaders are similar to dimensions and are governed by most dimension settings, but they
A)are not shown near the measured geometry.
B)are placed in the upper right corner of the drawing sheet.
C)do not show a measured value.
D)cannot be exploded.
Glencoe Online Learning CenterTrade & Industrial Education HomeProduct InfoSite MapContact Us

The McGraw-Hill CompaniesGlencoe

Please read our Terms of Use and Privacy Policy before you explore our Web site. To report a technical problem with this Web site, please contact the Web Producer.